Sky Power Co. is a licensed electrical contractor (CSLB #1037507) in Sherman Oaks. We handle the electrical side of air conditioners, heat pumps, electric water heaters and pumps in homes and businesses across Los Angeles.
Air conditioners and heat pumps
- A dedicated circuit from the panel to a new or replacement AC unit or heat pump
- The right breaker for the unit, and replacing a breaker that is worn out or trips
- An outdoor disconnect switch next to the unit, and replacing an old or rusted one
- Troubleshooting when the AC will not turn on because of an electrical problem: a tripped or failed breaker, a blown fuse in the disconnect, damaged wiring
- Checking whether your panel can carry a new AC unit or heat pump, and a panel upgrade when it cannot
Water heaters, pumps and thermostats
- A circuit and wiring for an electric or heat pump water heater
- Wiring for pool, well and other pumps
- Thermostat wiring, and line-voltage thermostats for electric heaters
What we do not do
We are electricians. We do not install, repair or recharge the AC unit itself, and we do not work on refrigerant, ductwork, gas lines or plumbing. For that you need a licensed HVAC contractor (C-20) or plumber (C-36). We can work together with your HVAC contractor or plumber: they install the equipment, we bring the power to it.
Permits
We pull the electrical permit and schedule the inspection: LADBS in the City of Los Angeles, or the city’s own building department in Burbank, Glendale, West Hollywood, Beverly Hills, Santa Monica, Malibu and Calabasas.
Related work
Service area
We work in Sherman Oaks, Studio City, Encino, Woodland Hills, Calabasas, Burbank, Glendale, West Hollywood, Beverly Hills, Santa Monica, Pacific Palisades, Malibu and anywhere in Los Angeles within 15 miles of Sherman Oaks.
Book a visit
Call (818) 588-1787 or request a quote. The service call is $135 during business hours and is waived if we do the work. We work Monday to Friday 8 am–6 pm and Saturday–Sunday 9 am–3 pm.
Questions and Answers
Do you install air conditioners?
No. We do the electrical work for them: the dedicated circuit, the breaker and the outdoor disconnect switch. The AC unit itself is installed by a licensed HVAC contractor.
My AC will not turn on. Can you help?
If the cause is electrical, yes: a tripped or failed breaker, a blown fuse in the disconnect or damaged wiring. If the electrical side is fine, you will need an HVAC technician for the unit itself.
Can my panel handle a new heat pump?
We check the panel and the load. If there is not enough capacity, we can upgrade the panel.
Do you install water heaters?
We run the circuit and connect electric and heat pump water heaters. Plumbing and gas connections are done by a licensed plumber.
Do I need a permit?
A new circuit for an AC unit, heat pump or water heater usually needs an electrical permit. We pull it and schedule the inspection.